The PTR sampler is installed at the discharge of a conveyor belt or in a chute between 2 conveyor belts. It consists of a leak tight casing that is attached to the housing of a conveyor belt discharge, and a sampling spoon that cuts laterally across the whole product flow.
Technical Data :
Sampling spoon real travel : depends on the belt width + around 100 mm
Sampling slot width : according to the product characteristics (min 3 times the dimension of the largest particle)
Spoon linear speed : from 0,4 to 0,6 m/s
Maximum allowable temperature : 120°
Welded profiled steel rigid frame structure
Moving part consists of a sampling spoon set up on a linearly moving steel structure, with the motor mounted on board, this is supported and guided on 4 adjustable steel rollers
Side leak tightness using brushes, upper and lower leak tightness using spring steel
Removable spoon with side deflectors constructed in wear resistant steel
