The sampling equipment type PRV is used to obtain a product sample in a vertical fall without modifying its particle size distribution.
The product is sampled by the rotating spoon attached to the tip of the sampler, and is then conveyed inside a DN100 cylinder, into which is welded a steel spiral. A gear motor drives the rotation of the whole assembly. The sample is discharged at the end of the steel cylinder and falls on to an inclined steel plate, that contains a volumetric chamber. The sample is into the chamber and the excess is returned back into the process.
Technical Data :
Rectangular flange mounting
Abrasion resistant steel spoon with a 75 mm width's calibrated opening
Barrel made of a mild steel tube DN 100 with mild steel welded thread
Main drive shaft welded on to the barrel by a tripod
Drive shaft supported by 2 ball bearing assemblies in a cast iron body
Drive motor : a gear motor assembly power 0,12 KW under 400 volts three phase 50 Hz set up with anti rotation arm
Frame for easy installation with predrilled holes for assembly
DN 80 output tube for sample collection
Dimensions :
Maximum allowable temperature : 120°
Tube length : from 100 to 250 mm (depending on the exact location configuration
